toutes les options
wheezy  ] [  jessie  ] [  sid  ]
[ Paquet source :  ]

Paquet : powstatd (1.5.1-9.1) [debports]

Liens pour powstatd

Screenshot

Ressources Debian :

Télécharger le paquet source  :

Introuvable

Responsables :

Paquets similaires :

Configurable UPS monitoring daemon

Assuming you have a relay-based "dumb" UPS that corresponds with your machine via a serial connection, you should be able to configure powstatd in just a few minutes. It is easily configured, and can be expected to support most "dumb" UPS supplies.

UPS models known to work:

 CyberPower PowerSL series
 CyberPower Power2000 1500VA
 CyberPower Power99 325VA, 400VA, 500VA and 720VA
 Some older CyberPower 385VA and 450VA models
 TrippLite Internet Office 500 UPS
 Various older APC units.

Powstatd can also be configured to allow a master machine to control (Via a network connection) up to 20 (by default) additional slave machines connected to the same UPS. This allows you to run several machines off the same UPS, with only one of the machines actually reading the UPS status over the serial line. This version of powstatd uses secure cryptography to communicate between master and slave(s), replacing the older powstatd-crypt Debian package.

Autres paquets associés à powstatd

  • dépendances
  • recommandations
  • suggestions
  • enhances

Télécharger powstatd

Télécharger pour toutes les architectures proposées
Architecture Taille du paquet Espace occupé une fois installé Fichiers
arm64 (portage non officiel) 41,3 ko115,0 ko [liste des fichiers]